SE-100 Delux MK 2 Specifications
Frequency
Response: -0.1 dB from 20Hz to 20KHz at 1 Watt
Signal-to-Noise Ratio: Greater
than 120 dB below rated FTC Full Bandwidth Power
Slew Rate: 50V
microsecond
Input
Impedence: 40K
Ohm
Input
Sensitivity: 1.5Volt Peak-to-Peak for full output
Total
Harmonic Distortion (THD): Less than 0.01% at full rated FTC power from 20Hz to
20KHz.
Intermodulation
Distortion (IMD): Less than 0.05% from 250 mW to full
rated FTC power
FTC
Output Power:
100 Watts
RMS on 8 Ohms (Both Basic and Delux versions)
160
Watts RMS on 4 Ohms (Delux version)
200
Watts RMS on 4 Ohms (Special Edition, consul factory for details)
Power
Bandwidth: -3dB
from 5 Hz to 100KHz
Damping Factor: Better than 100
Voltage Gain: 26 dB.
Dimension: W9”x H5” x D12”, Net Weight
22 Lbs, Gross Weight: 25 Lbs
AC Voltage: 117/234V 50/60Hz
Power
Consumption: 180
Watts Idle, 250Watts full power
The
Mark 2 is identified by a
Laser Engraved legend “Mark 2” on the rear panel.
"SE" in the "SE-100" model
represents "Single-Ended".
This amp is best used as a
Single-Ended amp(with RCA connection)
The XLR connector provided is for:
1: Balanced connection if
absolutely necessary.
But being a
singled-ended
amp, this connection
does not necessarily
yield
better performance.
2: for extension to another SE-100
as a Bi-Amp or Tri-amp operation.
(please refer to our bi-amp
connection diagrams)
If True Balanced Operation is
desired, please consider our SM-70 PRO: a real Balanced amp
(with two amps per
channel).